Comme dans tout git, il y a dans 99% des cas un fichier README, faut le lire, pas attendre que d'autres le lisent à ta place....
Tu y liras
Encore une fois, pas de ma faute si leur doc est mal faite.
Je ne veux pas sembler "dur" mais ce n'est pas la première fois qu'on te dit comment utiliser le git . Là je me tape la lecture de leur doc et du git à ta place
Ce type d'erreur tu aurais pu le trouver tout seul en cherchant un peu
Le config va sans doute planter car des dépendances seront manquantes, il te faudra les installer (paquet éponymes , des fois le paquets de dev aussi, ou le paquet contenant la lib manquante)
Ex
Code : Tout sélectionner
serveur@serveurProliant:~/tvheadend$ ./configure
Checking support/features
checking for cc execinfo.h ... ok
checking for cc -mmmx ... ok
checking for cc -msse2 ... ok
checking for cc -Wunused-result ... ok
checking for cc -fstack-protector ... ok
checking for cc -fstack-protector-strong ... ok
checking for cc -fstack-check ... ok
checking for cc -fPIE ... ok
checking for cc strlcat ... fail
checking for cc strlcpy ... fail
checking for cc fdatasync ... ok
checking for cc getloadavg ... ok
checking for cc atomic32 ... ok
checking for cc atomic64 ... ok
checking for cc atomic_time_t ... ok
checking for cc atomic_ptr ... ok
checking for cc bitops64 ... ok
checking for cc lockowner ... ok
checking for cc qsort_r ... ok
checking for cc stime ... ok
checking for cc gmtoff ... ok
checking for cc recvmmsg ... ok
checking for cc sendmmsg ... ok
checking for cc libiconv ... fail
^ using build-in glibc iconv routines
checking for cc ifnames ... ok
checking for cc cclang_threadsan ... fail
checking for py module gzip ... ok
checking for pkg-config ... ok
checking for xgettext ... ok
checking for msgmerge ... ok
checking for gzip ... ok
checking for bzip2 ... ok
checking for pkg openssl ... fail (detected <none>)
checking for pkg libssl ... fail (detected <none>)
checking for cc openssl/ssl.h ... fail